|
 |
SKIVED JOINT
The CHIORINO transmission belts can be made endless using
a
standard skive; directions here below.
|
K cement |
for
polyamide |
PR - P - Z -
T - DG - LT - LL |
| |
for elastomer |
Z - T |
| R
cement
+
I hardener |
for elastomer
and leather |
DG - LT - LL |
| AD
cement
+
C hardener. |
for
MF elastomer |
DG MF |
| KIT |
Recommended directions
(the adhesives are packed into their own KITS) |
| NAILCOL |
Series PR - P - DG
Apply the K cement
on the polyamide part of the splices. Let dry for 5 minutes,
then match the belt ends, paying attention to align properly.
Press according to the instructions shown.
|
| CARBOCOL |
Series Z
Apply the K cement on the
polyamide part of the splices. Apply the H primer
on the elastomer part of the two splices and the B
cement on the elastomer part of a single splice.
Series T
Apply the K cement on the
polyamide part of the splices. Apply the H primer
on the four elastomer parts of the two splices and the B
cement on the two elastomer parts of a single splice.
_________________________________________
Let dry for 5 minutes, then match the belt
ends, paying attention to align properly. Press according
to the instructions shown. |
| GUMMICOL |
Series DG - LT - LL
Apply the K cement on the
polyamide part of the splices. Let dry for 5 minutes. Pour
the I hardener with the R cement
(pot-life 2-3 hours). Apply the above mix on the elastomer
or leather part of the splices. Let dry for 5 minutes, then
match the belt ends, paying attention to align properly. Press
according to the instructions shown. |
| MF
CARBOCOL |
Series DG MF
Apply the K cement on the
polyamide part of the splices and let dry for 5 minutes. Pour
the AD cement with the C hardener
(pot-life 2-3 hours) and apply the mix on the splices of the
top surface. Pour the I hardener with the
R cement (pot-life 2-3 hours) and apply the
mix on the splices of the driving surface. Let dry for 5 minutes,
then match the belt ends, paying attention to align properly.
Press according to the instructions shown. |
To ensure best joint life it is advisable
not to run or tension the belt for 24 hours.
FAST JOINT
The thermoplastic flat belts of the DU and AR series
can be made endless up to 80 mm wide in a very
short time with the fast joint system without use of cement,
by means of the equipment shown here below.
|
|
|
